Niagara Tridium T-600, Mounting Manual

Page: 1 / 28

MOUNTING AND WIRING GUIDE
Network Controller 6
T-600, T-600-USA
Network Controller 6 Mounting and Wiring Guide
Part Number 11843 Rev 2.1 Updated: January 16, 2012
1
JACE, Niagara Framework, Niagara AX Framework and the Sedona Framework are trademarks of Tridium, Inc.
:
Note
Not covered in this document is the Niagara
AX
software installation and configuration required for a
fully functioning unit. This includes setting host IP address and password, serial port configuration, and
other parameters. Refer to the
JACE NiagaraAX Install and Startup Guide for this information.
In addition, the mounting and wiring of JACE
®
expansion options are covered in separate documents.
See sections “Related Documentation,” page 4, and “About Expansion Options,” page 8.
These are the main topics included in this document:
•
Preparation, page 2
•
Precautions, page 3
•
Mounting, page 5
•
Board Layout, page 7
•
About Expansion Options, page 8
•
Wiring Details, page 11
–
Grounding, page 11
–
Power Wiring, page 11
–
Communications Wiring, page 14
–
RS-485 Biasing, page 16
•
Power Up and Initial Checkout, page 19
•
Using Status LEDs, page 21
•
Maintaining the T-600, page 22
•
Replacement Parts, page 23
•
Certifications, page 26
•
Tab Mounting Dimensions, page 28
This document covers the mounting and wiring of the Tridium
®
T-600
series (JACE 6) controller. It assumes that you are an engineer, technician,
or service person who is performing control system installation.
Instructions in this document apply to the following products:
Models Description
T-600, T-600-USA T-600 base unit controller, powered by (either):
NPB-PWR 24Vac/dc input/15Vdc output power module, DIN mountable
NPB-PWR-UN 90–263Vac universal input/15Vdc output power module, DIN mountable
WPB- XXX Wall-mount universal AC power adapter, with different models available,
where - XXX is either: -US, -EUR, or -UK (vary by AC wall plug).