Network Controller 6 Mounting and Wiring Guide
Updated: January 16, 2012
Mounting
Removing and Replacing the Cover
6
Figure 1
T-600 controller and accessory mounting details.
Removing and Replacing the Cover
You must remove the T-600 cover to connect the battery (new unit) or to replace the battery, and to install any
option boards. The cover snaps onto the base with four plastic tabs (two on each end).
To remove the cover, press in the four tabs on both ends of the unit, and lift the cover off. See
Mounting on DIN Rail
Removing from DIN Rail
T-600
T-600
T-600
7.13” (181 mm)
6.38” (162 mm)
10.35” (263 mm)
13.58” (345 mm)
16.81” (427 mm)
20.04” (509 mm)
23.27” (591 mm)
4.1”
(104 mm)
2.05” (52 mm)
NOTE: If installing
T-IO-16 modules and
using the NPB-PWR or
NPB-PWR-UN power
supply module, the power
supply module installs at
the
end
of the chain.
Install DIN rail End Clip
(Stop Clip) at both ends of
final assembly.
DIN rail
End Clip
NPB-PWR or
NPB-PWR-UN
NPB-PWR or
NPB-PWR-UN
T-IO-16
T-IO-16
T-IO-16
T-IO-16
T-IO-16
DIN Rail
End Clip
Up to four (4)
T-IO-16 modules
are supported.