Stationary Installation
25
The following table contains the steps for installing your modem for continuous power
connection:
1
Insert the power connector into the 2-prong jack labeled POWER
located on the rear panel of the modem (Figure 3).
2
Plug the other end of the power connector to a 120VAC power
supply.
3
Insert the Ignition Sensor Short Plug into the 4-prong jack labeled
IGNITION located on the rear panel of the modem (Figure 3).
Modem Data Cable Installation
The iR1200 Rugged Modem can be connected to the host DTE equipment using a
standard “straight through” 9-pin to a 9-pin serial cable.
The following part can be used:
1
5200-C5-RFM – eLutions Power Cable
The following table contains the steps for connecting the data cable:
Connect one side of the 9-pin cable to the iR1200 communication
connector and the other side of the DTE.
GPS (optional) Data Cable Installation
The iR1200 GPS Enabled Modem can be connected to the host DTE equipment using a
standard “straight through” 9-pin to a 9-pin serial cable.
The following part can be used:
2
5200-C5-RFM – eLutions Power Cable
The following table contains the steps for connecting the data cable:
Connect one side of the 9-pin cable to the iR1200 communication
connector and the other side of the DTE.
