Please read and follow the notes below for the safe operation of your Dash Cam within your
vehicle.
As per the installation instructions, you must install the Dash Cam so it does NOT obstruct the
drivers view of the road, preferably on the passenger side of the vehicle and behind the rear view
mirror. Whilst the Dash Cam clearly needs to view through the windscreen in an area swept by the
windscreen wipers, the Dash Cam should be installed so as not to intrude significantly within the
wiped area. A 40mm intrusion into the green wiped area is the maximum permitted by law.
Do NOT mount the Dash Cam in front of the driver, as depicted by the red area in the above
illustration.
When installing the Dash Cam in a vehicle, always place the device securely against the
windscreen and where possible conceal the power cable under trim. Make sure that the Dash Cam
power cable does not interfere with the drivers operating controls, such as the steering wheel,
pedals or gear levers.
Do NOT mount the Dash Cam in front of an airbag field of deployment or in a position to obscure
any mirrors.
Clean the windscreen at the point of location, prior to fitting the Dash Cam, also, applying some
moisture to the suction cup may be beneficial, to ensure absolute adhesion.
It is recommended NOT to operate the Dash Cam whilst driving. The automatic Start-Stop
technology incorporated within the device negates any need to operate the controls whilst driving.
Adjust any settings or review recordings whilst stationery, not whilst driving.
Only use your mobile device whilst stationery, not whilst driving.
After the preliminary SETUP has been carried out upon the Dash Cam, adjust the Screen Saver
setting to On, this will blank the screen automatically shortly after starting the vehicle and
therefore the screen will NOT be a distraction in any way to the driver.
IN VEHICLE INSTALLATION (CONTD.)
17
