Failure to comply with these instructions could result in a fire or explosion that could
cause serious bodily injury, death, or property damage.
Your barbeque will be very hot. Never lean over the cooking area while using your
barbeque. Do not touch cooking surfaces, firebox, hood or any other parts while the
barbeque is in operation, or until the barbeque has cooled down after use.
DANGER
If you smell gas:
•
Shut off gas to the appliance.
•
Extinguish any open flame.
•
Open hood.
•
If odour continues, keep away from the
appliance and immediately call your
gas supplier or your fire department.
WARNING
1.
Do not store or use gasoline or other
flammable liquids or vapours in the
vicinity of this or any other appliance.
2.
An LP cylinder not connected for use
with the appliance shall not be stored in
the vicinity of this or any other
appliance.
DANGER
1.
Never operate this appliance unattended.
2.
Never operate this appliance within 3.05 m / 10 ft. of any structure, combustible material
or other gas cylinder.
3.
Never operate this appliance within 7.62 m / 25 ft. of any flammable liquid.
4.
Never operate this appliance with more than one accessory hot plate (model no. 650-0888)
at the same time.
5.
Do not fill cooking vessels used beyond the maximum fill line.
6.
Heated liquids remain at scalding temperatures long after the cooking process. Never
touch cooking appliance until liquids have cooled to 46 ºC / 115 ºF or less.
6.
This appliance is not intended for and should never be used as a heater.
7.
If a fire should occur, keep away from the appliance and immediately call your fire
department. Do not attempt to extinguish an oil or grease fire with water.
Safety Instruction
3
Summary of Contents for 720-0888T
