Nexcom EBC575 Series, Manual

Page: 53 / 79

53 Chapter 4 EBC575 User’s Manual
This option opens a dialog box that lets you install optimized defaults for all appropriate items in the whole
setup utility. Press the <
Y > key and then < Enter > to install the defaults. Press the < N > key and then < Enter >
to not install the defaults. The optimized defaults place demands on the system that may be greater than the
performance level of the components, such as the CPU and the memory. You can cause fatal errors or
instability if you install the optimized defaults when your hardware does not support them. If you only want to
install setup defaults for a specific option, select and display that option, and then press the <
F7 > key.
4.16 Set Supervisor/User Password
The Supervisor/User Password utility sets the password. The main board is shipped with the password
disabled. If you want to change the password, you must first enter the current password, then at the prompt
enter your new password. The password is case sensitive. You can use up to eight alphanumeric characters.
Press <
Enter > after entering the password. At the next prompt, confirm the new password by retyping it and
pressing < Enter > again.
To disable the password dialog box appears. A message appears confirming that the password has been
disabled. If you have set supervisor and user Password, only the supervisor password allows you to enter the
BIOS setup program.
Note: If you forget your password, the only way to solve this problem is to discharge the CMOS memory by
turning power off and placing a shunt (jumper cap) on jumper JP2 to short pin 2 and pin 3 for five
seconds, then putting the shunt back to pin 1 and pin 2 of JP2.
4.17 Save & Exit Setup
Selecting this option and pressing < Enter > will save the new setting information in the CMOS memory and
continue with the booting process.
4.18 Exit Without Saving
Selecting this option and pressing < Enter > will exit the Setup utility without recording any new values or
changing old ones.
This concludes Chapter 4. The next chapter covers drivers installing.