Nexcom EBC 300 Series, User Manual

Page: 8 / 22

EBC 300 User’s Manual 8 Chapter 1
- Internal CompactFlash socketx1
Support One Type II CompactFlash Card (Secondary)
- On Board Power LED and HDD Active LED Pin Header
Audio - REALTEK ALC655-LF AC97 CODEC
- Microphone in, Speaker out (external)
I/O Interface
-
SIO
×
1, with 1x16C550 UARTs, One DB9 Connector
- USB2.0 connector x 6 (two direct output, 4 from Jst Box Header)
- HDD: Support IDE with 44 pin connector
×
1 (Secondary)
- Internal CompactFlash socket x 1
Support One Type II CompactFlash Card (Primary)
- On Board 2 pin header for Reset switch
- 8 GPIO lines via header (GPI 0~3 and GPO0~3)
- TTL Level (0/5V)
- On Board HDD Active LED Pin Header
- Reserved 3 PIN FAN Connectors x 1 (for CPU)
- On board 3 pin header for I2C, one pin for GND
- PC/104 Plus Connector x 1
Expansion Slot
-
PC/104 Plus Connector x 4 (PCI Only)
I/O on Bracket
- VGA
- RJ-45
- Mic-In
- Speaker Out
- COM
- USB x 2
System Management
- Derived from Super IO to support system Voltage, fan speed, temperature
monitoring
- Watchdog Timer: Watchdog timeout can be programmable by Software
from 1 second to 64 Sec. (Tolerance 10% under room temperature 25°C)
Real Time Clock
- On chip RTC with battery back up
- External Li-ion Battery x 1 (Socket type field replaceable)
- The Battery Socket should be Flat direction.
Tolerance less 2 sec ( 24 hours ) under 25
°
C environment
Dimensions
- 146mm(L) x 105mm(W)
Power Supply
- AT Mode: +5V Power in, No Power On push Button, Software Shutdown
function and LAN remote wake up; BIOS and H/W is default to AT Mode
- ATX Mode: +5V / +12V /-12V / -5V / 5Vsb Power In
When Change to ATX Mode, the BIOS default setting is as follow:
POWER -SUPPLY TYPE [ATX]
AUTO PWR-FAILURE RESUME [ON]