Safety Regulations
User Manual for AZ710 Up Converter
version 1.2
iv
SHAPING THE FUTURE OF SATELLITE COMMUNICATIONS
SAFETY REGULATIONS
Please read this chapter before you install and use this equipment.
To ensure your safety, the equipment has been designed to comply with the
following safety standard:
IEC 60950 Safety of Information Technology Equipment
Before you start to install and operate the device, please make sure you observe
the following:
The equipment described in this manual is designed to be used by properly trained
personnel only. Only qualified personnel who are aware of hazards involved may
adjust, maintain and repair the exposed equipment.
No operator serviceable parts inside. Refer servicing to qualified
personnel. To prevent electrical shock, do not remove covers.
To use the equipment correctly and safely, it is essential that both operating and
servicing personnel follow generally accepted safety procedures in addition to the
safety precautions specified in this manual. Warning and caution statements and/or
symbols are marked on the equipment when necessary. Whenever it is likely that
safety protection is impaired, immediately switch off the equipment and secure it
against unintended operation. Inform the appropriate servicing authority about the
problem. For example, safety is likely to be impaired if the equipment fails to
perform the intended measurements or shows visible damage.
Caution1:
FOR CONTINUED PROTECTION AGAINST FIRE, REPLACE
LINE FUSES ONLY WITH SAME TYPE AND RATING (5 X 20mm
T3.15 A/250v TYPE T or slow-blow).
Caution 2:
THERE IS RISK OF EXPLOSION IF THE BATTERY IS
REPLACED WITH AN INCORRECT TYPE. DISPOSE OF USED
BATTERIES ACCORDING TO THE INSTRUCTIONS.
