Newport NPC1USB, User Manual

Page: 30 / 48

NPC1USB Voltage Piezo USB Amplifier
SA — Set/Get Controller’s RS-485 Address
Usage Not Ref. Config. Disable Ready Motion
–

– – –
Syntax xxSAnn or xxSA?
Parameters
Description xx [int] — Controller address.
nn [int] — Controller’s axis number.
Range xx — 1 to 31.
nn — 2 to 31.
Units xx — None.
nn — None.
Defaults xx Missing: Error B.
Out of range: Error B.
Floating point: Error A.
nn
Missing: Error C.
Out of range:Error C.
Description The SA command sets the controller’s RS-485 address.
Newport Corporation recommends using the supplied utility software for all controller
configurations. The SA command is of practical use only when not using this software.
Returns If the sign “?” takes place of nn, this command returns the current programmed value.
Errors A — Unknown message code or floating point controller address.
B — Controller address not correct.
C — Parameter missing or out of range.
D — Execution not allowed.
H — Execution not allowed in NOT REFERENCED state.
J — Execution not allowed in DISABLE state.
K — Execution not allowed in READY state.
L — Execution not allowed in HOMING state.
M — Execution not allowed in MOVING state.
Rel. Commands
None.
Example
1SA3 | Set controller’s RS-485 address to 3.
EDH0403En1010 — 07/17 24