Newport i16-AL, Operator'S Manual

Page: 19 / 48

15
3.2.2 Set Points Menu
SETPOINT 1:
Press
a
Press
d
Press
b
&
c
1) Press
a
, if necessary until
SP1
prompt appears.
2) Display shows previous value of “Setpoint 1”.
3) Press
b
and
c
to increase or decrease Setpoint 1
respectively.
Holding
b
&
c
buttons down for approximately 3 seconds will speed up
the rate at which the Setpoint value increments or decrements.
Press
b
&
c
Press
d
4) Continue to use
b
and
c
to enter your 4-digit Setpoint 1
value.
5) Display shows
STRD
stored message momentarily and then
advance to
SP2
only, if a change was made, otherwise press
a
to advance to
SP2
Setpoint 2 Menu.
SETPOINT 2:
Press
d
Press
b
&
c
6) Display shows previous value of “Setpoint 2”.
7) Press
b
and
c
to increase or decrease Setpoint 2
respectively.
Holding
b
&
c
buttons down for approximately 3 seconds will speed up
the rate at which the Setpoint value increments or decrements.
Press
d
8) Display shows
STRD
stored message momentarily and then
advance to
CNFG
only, if a change was made, otherwise press
a
to advance to
CNFG
Configuration Menu.
Setpoints are used for Deviation only.