12
15272 Newsboy Circle
Huntington Beach
California 92649
Phone: 714-751-0488
Fax: 714-856-9679
E-Mail: [email protected]
PoweringTheNetwork.com
2)
Digital Meter Programming Sequence:
Screen diagram reference number, corresponds to flow chart on page 11.
1)
Home screen: displays DC voltage & total amperage consumed by system (loads and battery charge current), and
temperature in degrees Celsius. When in programming mode the screen will revert to home after 30 second of
inactivity. Note, it is normal the ammeter may toggle between 0 and 1 amp with no load or battery connected.
1B)
If system battery is disconnected, screen will automatically display “Batt Offline” until battery is reconnected.
Rotating the knob will select other screens, or pushing the menu button will take you directly to the alarm screen.
2)
LVD settings Screen: Displays the disconnect and reconnect voltages
Rotate knob to:
3)
Ambient Temperature Screen: Displays temperature in degrees C and F.
Rotate knob to:
4)
Programming Portal Screen: Displays when in 'ready to program' mode; push of menu button to move to
programming screens, or rotating knob displays alarm screen (#5)
4A
->LVD voltage disconnect Screen, press programming button to enter set mode, rotate knob to change, push to
confirm setting. See page 13 for detailed directions.
4B
->LVD voltage connect Screen, press programming button to enter set mode, rotate knob to change, push to
confirm setting. See page 13 for detailed directions.
4C
->LVC pre disconnect voltage screen, press programming button to enter voltage at which pre trip alarm should
activate, push to confirm setting. See page 13 for detailed directions.
Rotate knob to:
4D
Display brightness setting , press programming button to enter adjustment mode, rotate knob to change, push
button to confirm
Rotate knob to:
4E)
Restore factory setting screen, press programming button to access authorization screen, rotate knob to yes if
you wish to apply factory global factory default settings, press programing button to confirm.
Rotate knob to:
4F)
Exit screen, press programming button to return to Programming portal screen (ref #4)
5)
Alarm system status screen: displays ’system ok’ if no alarms have been tripped.
5B)
If alarm conditions are present, screen will automatically display what alarm condition has occurred”
• BRK OFF= Breaker off
• LVDdiscon= Low voltage disconnect activated
• Prelvd= voltage approaching disconnect point, disconnect eminent.
• CHK PM= Summary alarm received from rectifier
Rotate knob to return to Home screen.
