49
Configuring the NQuire with Programming Barcodes
The NQuire can be configured by scanning programming barcodes which are created in the format of
Code 128.
Enter/Exit the Setup Mode
Scanning the
Enter Setup
barcode can enable the NQuire to enter the setup mode. Then you can scan a
number of programming barcodes to configure the NQuire. To exit the setup mode, scan the
Exit Setup
barcode.
Enter Setup
Exit Setup
Enable/Disable DHCP
If DHCP is disabled, the NQuire will have a fixed IP address and it will use the most recently configured IP
address. The default IP address is 192.168.1.200
If DHCP is enabled, the NQuire will function in DHCP mode and it is not necessary to put your own network
environment in the default range 192.168.1.xxx
Enable DHCP
Disable DHCP