nlscan.com
Page 78
Symbols
Tools
Code Programming ON
Code Programming OFF
Select Message Length
It is used to program the valid reading length of Interleaved 2 of 5. The engine
will send an error beep, if the decoded data length does not match the valid
length.
Interleaved 2 of 5 Message Length is de
fi
ned by
“
Min. Message Length
”
and
“
Max. Message Length
”
Interleaved 2 of 5
1D bar code Message Length should not exceed 255 bytes. If Max Message Length is
less than Min Message Length, it means the engine will only support barcodes of the two
lengths. If Max Message Length is equal to Min Message Length, the engine will only sup-
port barcodes of the length.
To set Min Message Length of Interleaved 2 of 5 as 8 bytes, and Max Message length as 12
bytes, read these programming codes:
1.
“
Code Programming ON
”
2.
“
Select Min Message Length
”
3. Digit Code
“
8
”
, see Digit Code Appendix (Pxxx)
4.
“
Save Programming
”
, see Digit Code Appendix (Pxxx)
5.
“
Select Max Message Length
”
6. Digit Code
“
1
”
7. Digit Code
“
2
”
8.
“
Save Programming
”
9.
“
Code Programming OFF
”
Min Message Length
【
Pro CMD
：
99911206
】
Max Message Length
【
Pro CMD
：
99911207
】
