5. OPERATION INSTRUCTIONS
Liquid Crystal Display (LCD)
1 – Low Battery indicator; 2 – Reticle (cross or rectangular selectable);
3 – Units of measurement (Yards, Meters, KMH,
MPH); 4 – Measurement result;
5 – Target Quality indicator (optional); 6 – Laser Active indicator
7 – Over 100m indicator (optional).
Fig. 3
8
The displayed statistical qualification of the reflected signal
characterizes variation in expected accuracy of measurements. At
qualification
HIGH
the accuracy of measurements is stated as
±
1m. At lower rates of statistical qualification the expected
accuracy may marginally degrade.
Please note:
this indicator is optional and may be not activated
in your device.
The display presents
LOW BATTERY
pictogram, when voltage
of the primary 9-volt battery drops below 7.2 volt. At this point
the System is still functional but the battery should be replaced
as soon as possible. The System can operate at the voltage level
above 7 volt. The System should be powered with Alkaline or
Lithium type of batteries capable to sustain current drain up to
150 mA.
The System remains in the active displaying state for 10 seconds
after pressing of any of the operating buttons and afterwards it
enters the passive low power state.
OVER 100m
indicator is reserved for the future development. It
is not in use in the current configurations.
13
4
6
2
7
1
5
3
