New World NWDHT1014DG, Instruction Manual

Page: 14 / 44

Installing your washing machine
Bringing it all together
Installing your <washing machine>
14
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
or online at www.newworldassist.co.uk If you still require further assistance, call one of our experts on 0333 305 2263 .
Unpacking your washing machine
Caution:
2 people are required to unpack the washing
machine, it is recommended that gloves are worn.
a: Carefully remove all packaging materials including
the foam base, dispose of correctly.
Note:
When opened, water droplets may be visible in
the drum etc. this is normal as each appliance is factory
tested.
Removing the packing bolts
Important:
The packing bolts are designed to support
the internal components during transit, these MUST be
removed before use.
a:
Loosen the screws by rotating counter clockwise
with a suitable wrench. (1 & 2)
b: Remove the bolts by pulling them. (3)
c: When the transport bolts have been removed,
insert the plastic transport screw taps found in the
accessories bag into the holes. (4)
Adjusting the feet
a:
For your machine to work efficiently with minimum
vibration it should be settled on flat, non-slippery, firm
ground.
b:
You can adjust the balance of your machine by
changing the positioning of its feet.
c: First, loosen the plastic adjustment nut. (5)
d: Adjust by rotating the feet upwards or downwards.
(6)
e:
After the desired position has been reached, tighten
the plastic adjustment nut again by rotating it upwards.
Note: Never put cartons, wooden blocks or similar
materials under the machine to balance irregularities
in the level of the ground.
X
4
X
4
1 2
X
4
3 4
5
6
X
4