New Holland Workmaster 25 Tier 4B, Operator'S Manual

Page: 117 / 198

7 - MAINTENANCE
7 - MAINTENANCE ###_7_###
General information
General information
WARNING
Illustrations in this manual may show protective shielding open or removed to better illustrate a par-
ticular feature or adjustment.
Replace all shields before operating the machine.
Failure to comply could result in death or serious injury.
W0012A
WARNING
Entanglement hazard!
Disengage the Power Take-Off (PTO), turn off the engine, and remove the key. Wait for all movement
to stop before you leave the operator's position. Never adjust, lubricate, clean, or remove a blockage
of crop material when the engine is on.
Failure to comply could result in death or serious injury.
W0227B
WARNING
Avoid injury!
1. Disengage all drives.
2. Engage parking brake.
3. Lower all attachments to the ground, or raise and engage all safety locks.
4. Shut off engine.
5. Remove key from key switch.
6. Wait for all machine movement to stop.
Failure to comply could result in death or serious injury.
W1197A
Adequate lubrication and maintenance on a regular schedule is vital to maintaining your equipment. To ensure long
service and efficient operation, follow the lubrication and maintenance schedules outlined in this manual. The use of
proper fuels, oils, grease and filters, as well as keeping the systems clean, will also extend machine and component
life.
NOTICE: While any company can perform necessary maintenance or repairs on your equipment, NEW HOLLAND
strongly recommends that you use only authorized NEW HOLLAND dealers and products that meet the given speci-
fications. Improperly or incorrectly performed maintenance and repair voids the equipment warranty and may affect
service intervals.
NOTICE: Always use genuine NEW HOLLAND replacement parts, oils and filters to ensure proper operation, filtration
of engine and hydraulic systems. See your NEW HOLLAND dealer for additional oil quantities.
Regular lubrication is the best insurance against delays and repairs. Proper lubrication will extend machine life. Refer
to the chart on page
7-8 for lubricants and service intervals.
NOTICE: Failure to complete the required maintenance at the recommended intervals can cause unnecessary down-
time.
The intervals listed in the Lubrication Chart are guidelines to be used when operating in normal conditions. Adjust
the intervals for operating in adverse environmental and working conditions. The intervals should be shortened for
sandy, dusty and extremely hot operating conditions.
Always clean the area around dipsticks, fill caps, and check plugs when checking fluid levels. Failure to clean these
areas may allow contamination to enter the system. Drain, flush and refill the system any time you suspect it is
contaminated.
Grease Fittings
Wipe dirt from fittings before greasing.
7-1