INTRODUCTION
Heating or cooling of parts installed with interference
• In the case of bearings, it is a good practice to heat them
for their installation. The expansion of the heated parts
reduces the force needed for installation, facilitating the
procedure and reducing the chance of damage to them.
• The heating should never be done under the action of
direct fire on the parts. Use oil heated at 80 to 90 0 C
or heating by electrical induction see figure.
• On the other hand, tapered bearing shafts and cups can
be cooled to reduce its diameter, also facilitating their
installation.
• Cooling can be done in freezers or with ice (dry or reg-
ular).
BAIL14SE00803AR
17
GENERAL RECOMMENDATIONS
ASSEMBLY SIDE
• Several components of the machine have parts whose
assembly side must be observed.
• In the row units, such components have a marking, in-
dicating it should be installed on the right side (from the
point of view of who is behind the machine). See ex-
amples in the figure, indicated by the arrows.
BAIL14SE00803AS
18
Bolts in general
In the case of bolts that allow the installation in both direc-
tions, the standard factory installation is from left to right.
BAIL14SE00803AT
19
47918066 10/09/2015
23
Summary of Contents for PS2045
Page 2: ...SERVICE MANUAL PS2045 Mechanical 47918066 10 09 2015 EN Find manuals at https best manuals com...
Page 5: ...47918066 10 09 2015 Find manuals at https best manuals com...
Page 6: ...INTRODUCTION 47918066 10 09 2015 1 Find manuals at https best manuals com...
Page 31: ...This as a preview PDF file from best manuals com Download full PDF manual at best manuals com...