NEW ENERGY NE-B245/100E, Installation And Operation Instruction Manual

Page: 17 / 21

16
hour position blinking display , press “ ”or “ ”to modify hour value ,press “ ” to confirm and “1 ”
、
“OFF ”symbols blinking display .the minute position blinking display ,press “ ”or “ ”to modify minute
value ,then press “ ” to confirm then enter hour setting ,the hour position blinking display , press “ ”or
“ ”to modify hour value ,press “ ”to confirm and enter “2 unit timing startup ”
，
its operation same as
above .
1.3.9.3 Exit timing setting :in timing setting status ,press “ ” or in 20s without any key operations then quit
current timing setting and exit timing setting status .
1.3.9.4 Cancel timing setting; after enter timing setting status, long press “ ” for 3 secs to cancel the
configured timing function.
1.3.10 Memory function :in shutdown status ,long press “ ” for 3 secs,the LCD display “POSET”then enter
memory function setting ,press “ ”or “ ”to set value as “on” or “off ”;If value is “on ”,the wired contact
memory setting status before powering off .if value is “off ”wired controller memory shutdown status .
1.3.11 Backlight setting ; in shutdown status ,long press “ ” for 3 secs, the LCD display “LCD SET” then
enter backlight setting ,press “ ”or “ ”to adjust the brightness. Press any keys except “ ”or “ ”
to save setting or if no any keys operation in 5s the controller will save current setting and exit.
1.3.12 Running parameters list:
No. Status name
Units
Indication
range
Remarks
d01 DC inverter compressor current actual frequency Hz 0
～
150
d02 DC inverter compressor run (input )current A 0
～
30.0
d03 exhaust gas temperature
℃
-15
～
999
d04 return gas temperature
℃
-30
～
999
d05 evaporator coil temperature
℃
-30
～
999
d06 outdoor am temperature
℃
-30
～
999
d07 inlet water temperature
℃
-15
～
999
d08 outlet water temperature
℃
-15
～
999
d09 Electronic expansion value pulse step count P 0
～
500 pulse step count
d10 DC-link voltage V
0
～
500
d11 module temperature
℃
-15
～
999