NEW ENERGY NE-B245/100E, Installation And Operation Instruction Manual

Page: 19 / 21

18
2.2 solutions
phenomenon reason check clear
The machine does
not work,
operation panel
with a display
But cannot be
switched,
button is failure 1: Operation panel line
not connected;
2: Operation board is
broken;
3: Disturbed;
4: Voltage Low;
5: The electronic
control board is broken 1: Check the line;
2: Alternative Method;
3: Check the source of interference;
4: Check the line voltage;
5: Alternative Method 1: Connect the line;
2: Change operation panel;
3: Eliminate interference source
replace line (with shield);
4: Transformation of the line or
increase Regulators;
5: Change electronic control
board
The machine does
not work,
the operation
panel display
1: Transformer is
broken;
2: Operation plate line
not connected;
3: Operation board is
broken;
4: The electronic
control board is broken
5: Disturbed 1: Measuring with a multimeter;
2: Check the line;
3: Alternative Method;
4: Alternative Method;
5: Check the interference lines have
unshielded cable or not 1: Replace the transformer;
2: Soldering iron;
3: Change the Control Panel;
4: Change electronic control
board;
5: Eliminate interference source
replace line (with shield)
Fan does not
work, and without
supply input
1: Power outages;
2 Circuit breaker;
3:The electronic control
board is broken (no
output);
4: Transformer is
broken 1: Measuring line voltage;
2: Measuring line;
3: Measure the output voltage;
4: Measuring winding, measuring the
output voltage 1: Wait to restore power;
2: Connect the line;
3: Change electric boards;
4: Change transformers
Fan does not
work, capacitor is
broken 1:Capacity
becomes smaller;
2: Open circuit;
3: Short circuit; 1: Check the capacity of the
capacitor;
2: Measuring with a multimeter;
3: Measuring with a multimeter 1: Change capacitor;
2: Change capacitor;
3: Change capacitor
Fan does not
work, motor
breaks down
1: The motor winding
road blocking, short
circuit, ground wiring 1: measuring winding 1: Change motor
Compressor does
not work, the 1: No Power;
2: Set the temperature 1: Check the operation panel;
2: Check the set temperature; 1: Power on;
2: Reset;
6 A26 Return gas sensor fault 16 A62
Compressor(input) Excessive current
fault
7 A11 Reserved 17 A63 Exhaust gas temp.overhigh protection
8 A12 LP switch abnormal failure 18 A64 Winter antifreeze protection
9 A13 HP switch abnormal failure 19 A70-A93 IPM module protection
10 A14 Reserved