19
Installation
New Brunswick Innova
®
2000/2050 Shaker
English (EN)
4.4
Electrical connections
Before making electrical connections, be sure to follow these instructions:
1. Check the voltage selector in the Universal Power Module at the rear of the unit to ensure that it is set to
the appropriate voltage.
2. Remove the CAUTION label from the universal power module.
3. Make sure the power switch on the back of the unit is set in the OFF position.
ONLY THEN:
4. Connect the power cord to the universal power module and to a grounded electrical outlet.
4.5
Install the platform
A platform (purchased separately) must be installed on the unit prior to use.
1. Set the mains/power switch to off.
2. Place the platform on the subplatform. Make sure that all four slots are seated over the four knob
screw-shafts. Be sure to use a platform of the proper size for your particular shaker.
3. Tighten the four knobs to secure the platform.
4.6
Install flask clamps
WARNING! Risk of electric shock and/or damage to device!
Use a grounded power supply.
CAUTION!
A detachable main power cord has been provided with your unit.
Only use the cord provided with the unit.
NOTICE! Risk of damage to device!
Never run shaker without a platform.
WARNING!
Do not overfill flasks (i.e., more than 50% of the flask volume).
