NEW BRUNSWICK SCIENTIFIC innOva 4200, Manual To Operation

Page: 43 / 73

43
Innova 4200
•
M1233-0053 User’s Guide
24. Replace and tighten the four
NUTS
that are on the
STUD SCREWS
to secure the
BEARING HOUSING
.
25. Replace the shaker platform. Replace the four
HEX SCREWS
into the center of the
platform and tighten with the
HEX KEY
.
26. Replace all shelving.
27. Replace the small panel and on the left side of the shaker. Replace the eight Phillips
(+) head screws and tighten with a Phillips (+) head screwdriver.
28. Lift up hinged front panel and replace the three screws. Use a Phillips (+) head
screwdriver to tighten the screws.
29. Close the door of the shaker.
30. Reconnect the
POWER CORD
to the electrical outlet.
9.6 Light Replacement
WARNING!
Only a qualified Service Engineer may perform this procedure.
The fluorescent light for the shaker is on the back, left wall of the cabinet. Two clips
hold the light in place; one clip is on the top and the other is on the bottom. Four wires
connect the light to the
TERMINAL BLOCK
.
To replace the light in the Innova 4200:
1. Set
the
ON
/
OFF POWER SWITCH
to
OFF
.
2. Disconnect the
POWER CORD
from the electrical outlet.
3. Remove all the shelving from the inside cabinet.
4. Open the door of the shaker. Use a Phillips (+) head screwdriver to unscrew the three
screws that attach the hinged front panel to the housing. Gently lay down the front
panel.