Rev. 00 of 12.06.09
10/18
2 . 3
– S t a r t o f s t i m u l a t i o n
Once selected a pre-set program or after having regulated the parameters in
the manual functioning area, the display shows
START
. Press the relative
START
to begin the therapy.
After having pressed
START
, the device places itself a stand-by state;
during this phase the machine will wait 30 seconds for the pedal arming the
LASER to be pressed.
Having pressed the pedal once passes to
LASER ARMED
state, in this
situation the LASER emits only the red pointing light.
Pressing the pedal a second time passes to EMISSION state where the
therapeutical LASER also is emitted.
2 . 4
– S e t t i n g t i m e a n d i n t e n s i t y o f e m i s s i o n
The duration of the therapy and the intensity can be set at any time by
rotating the encoder.
PRESS THE KNOB
repeatedly to pass from the
intensity parameter to the time parameter and vice versa. The minimum
density increase is of 1% and the maximum settable intensity is 100%, the
minimum time increase is of 1 minute.
2 . 5
– I n t e r r u p t / e n d t h e r a p y
Treatment emission is interrupted automatically when the Timer reaches 0
and an acoustic signal is heard. If you wish to interrupt treatment before the
end, press the pedal or
STOP
(on touch screen) (on the front panel). After the
pause, to restart treatment press
the pedal twice
.
2 . 6
– T u r n i n g d e v i c e o f f
In order to turn the device off, turn the key or press the switch on the back of
the device.
2 . 7
– C o n f i g u r a t i o n
The LASER devices can be set-up according to personal requirements.
Press
CONFIGURE
(on touch screen) to access the setting area.
This section displays the following entries:
1) language: Italian, English, French, German, Spanish, Portuguese
2) brightness of display: from 0 to 10
3) volume of buzzer: from 0 to 10
Summary of Contents for Hi-Laser Beta LASER
Page 2: ...Rev 00 of 14 01 10 2 24...
