I. Instructions for the installer
Dear customer,
Thank you and congratulations for the purchase of our product. The following notes and
recommendations concern the correct installation, operation and maintenance, to ensure
your safety and a better functioning of your device.
1. Type plate
The type plate is located on the cable output side. The technical characteristics are shown
in the following section "Technical data". The "CE" marking of the devices included in this
manual refers to the EC Directives 73/23 / EEC and 89/336 / EEC.
2. Specifications
Neumärker Chromium Steel Griddle
art.-no. 11-80188
230 V / 3,4 kW
art.-no. 11-80189
400 V / 6,8 kW
art.-no. 11-80190
400 V / 10,2 kW
3. Installation
The 400 V devices have 2 phases and are equipped with a CE plug. Important: It is only
allowed to connect max. 3.6 kW or 16 A to each phase. If more than 3.6 kW has been
connected, the fuse will immediately disconnect the power supply.
3.1 Positioning
The unit has to be positioned on a place to enable the subsequent electrical installation
and maintenance of the unit. The appliances are neither suitable for integration into a
kitchen unit nor for installing in line.
If the unit has to be set-up close to walls, partition panels, kitchen cabinets, decorative
edgings, etc. you have to make sure that these have not been made from flammable
material. Otherwise they have to be insulated with a heat-resistant and non-flammable
covering. Please adhere to the fire prevention regulations.
3.2 General instructions
Carefully pull off the protective foil from the stainless steel surfaces to prevent any glue
residue from remaining. If glue residues should remain, they must be removed with a
suitable solvent. In addition to the installation itself (only for non-plug-in devices), any
maintenance work may only be carried out by an authorized installer.
