3.3 Electrical connection
The connection to the power supply must be carried out according to the relevant
regulations. Before carrying out the electrical connection, make sure that the voltage and
the frequency correspond to the specifications on the type plate of the appliance.
When the device is operating, the supply voltage must not deviate from the rated voltage
by more than ± 10%.
The device must be connected to the earth conductor of the power supply.
3.4 Function check
Switch on the unit according to our following operating instructions. Explain to the operator
how to set the unit into work as well as its function by using our operating instructions.
3.5 Maintenance
Before carrying out any maintenance work, make sure that the unit has been disconnected
from the power supply and wait until the unit has cooled down.
All components requiring
maintenance are accessible after removal of the floor plate. We recommend to let the unit
be inspected regularly by a specialist (at least once a year).
II. Operating instructions
Attention:
Do not clean the appliance with a water jet.
The unit is intended for professional use and
may only be used by qualified personnel.
1. Instructions for the user
Note:
Please study carefully our operating
instructions as they give you important advices
regarding to your safety during installation, operation and maintenance. Pass on these
operating instructions to any further user of this unit. Contact only an authorized technical
service for carrying-out repairs and insist on using original spare parts. Failure to observe
our above instructions may affect your safety when operating the unit.
2. Operating instructions
Important:
The grill plates become very hot during operation. Use the unit only for the explicit
purposes, i.e. heating up food products. We strictly prohibit inappropriate use.
Do not use the grill plate to heat up pots and pans. Do not place aluminium foil or
plastic containers onto the plate.
Before the operation clean the plate with a cloth soaked with cooking fat. Put a very
thin fat coat onto the plate.
Afterwards turn the unit on, adjust it to 200°C and let it run for approx. 1 hour.
