Neue IDSH604W, User Manual

Page: 7 / 20

Water hardness
German degrees
(°dH)
French degrees
(°fH)
mmol/l Clarke de-
grees
Water softener level
47 - 50 84 - 90 8.4 - 9.0 58 - 63 10
43 - 46 76 - 83 7.6 - 8.3 53 - 57 9
37 - 42 65 - 75 6.5 - 7.5 46 - 52 8
29 - 36 51 - 64 5.1 - 6.4 36 - 45 7
23 - 28 40 - 50 4.0 - 5.0 28 - 35 6
19 - 22 33 - 39 3.3 - 3.9 23 - 27
5 1)
15 - 18 26 - 32 2.6 - 3.2 18 - 22 4
11 - 14 19 - 25 1.9 - 2.5 13 - 17 3
4 - 10 7 - 18 0.7 - 1.8 5 - 12 2
<4 <7 <0.7 < 5
1 2)
1) Factory setting.
2) Do not use salt at this level.
Whether you use a standard detergent or multi-tabs
(with or without salt), set the proper water hardness
level to keep the salt refill indicator active.
Multi-tabs containing salt are not
effective enough to soften hard water.
How to set the water softener level
The appliance must be in programme selection mode.
1. To enter the user mode, press and hold the
programme button until the indicator
flashes and the indicators
and are on.
2. Wait until the indicators and are off and
the indicator flashes. The indicator
still flashes. The intermittent flashing of the
indicator
shows the current setting.
• e.g. 5 f pause + 5 flashes = level 5.
3. Press programme button repeatedly to change the
setting. Each pressing of the programme button
increases the level number. After reaching level 10,
the count starts again from level 1.
4. Press the on/off button to confirm the setting.
Acoustic signals
Acoustic signals sound when a malfunction of the
appliance occurs. It is not possible to deactivate these
acoustic signals.
There is also an acoustic signal that sounds when the
programme is completed. By default this acoustic signal
is deactivated but it is possible to activate it.
How to activate the acoustic signal for the end of
programme
The appliance must be in programme selection mode.
1. To enter the user mode, press and hold the
programme button until the indicator
flashes and indicators
and are on.
2. Press the programme button immediately.
• The indicator and are on.
• The indicator flashes.
3. Wait until the indicator and are off. The
indicator still flashes.
• The indicator shows the current setting:
off = Acoustic signal off.
4. Press the programme button to change the setting.
• on = Acoustic signal on.
5. Press on/off confirm the setting.
AirDry
AirDry improves the drying results with less energy
consumption.
7