Modular Telecom Router
Rev. 4
3.6.1
Card insertion
To insert a X-point card, slide the module along the plastic guide rails into its
position. On both sides of the card tray there is a hole next to each module
slot. Use the two red handles, which are located on the front of the module to
seat the module. When the tip of both handles is just next to these holes, start
to push the handles
simultaneously
inwards the card. The tip of the handles
enters the hole and the card is locked and proper contact ensured when you
hear a click from both handles.
Note that it may be necessary to press hard when inserting the X-point
card(s). Be sure to press the card(s) firmly into the frame, before locking the
handles.
3.6.2
Card removal
To remove an X-point card from the frame, release the card by pushing the
red knobs on each handle until each handle releases from its locked position.
Then pull both handles simultaneously, and pull the card out of the frame.
3.6.3
Status LEDs
The front view of an X-point card is as follows:
22
