Modular Telecom Router
Rev. 4
The LEDs indicate the following:
Diode
Red
LED
Yellow
LED
Green
LED
No light
Status
Card error.
Not applicable.
Overall status of the
card is OK
Card has no power, or
is not inserted
correctly.
Eth
Not applicable.
Full duplex
connection.
Half duplex
connection.
No Ethernet link
established; check
cable.
Warn
Abnormal situation:
no functional error,
but a situation that
requires attention.
See also Chapter 6.
Not applicable.
Normal situation.
Not applicable.
Load
High load on the
μ
Controller.
May occur during
system start up and
software
reconfigurations / -
upgrades.
Medium load on the
μ
Controller.
Low, or normal load
on the
μ
Controller.
Not applicable.
Reset button
The reset button on the rear side is used to perform a hard reset of the card.
Do
not
perform a hard reset, unless the situation demands this. By performing
a hard reset, the user looses control of the router, and will not get control of
the router until approximately 20 seconds after releasing the reset button.
3.4.4
CF-card and battery
All the information regarding the router configuration, as well as information
regarding control panels that are connected to the router, is stored in the
Compact Flash card on the SysCon card.
If it is necessary to remove and/or insert a CF card, the following must be
done:
19
