NV-700I Managed Industrial VDSL2 CO/CPE Modem USER’S MANUAL Ver. A.5
10
2
NC
Unused
3
DSL
Used
4
DSL
Used
5
NC
Unused
6
NC
Unused
2.4 Terminal Block and DIN-Rail mount installation
This section describes how to install the Terminal Block and DIN-Rail to the modem, if you do not install the DIN-Rail, please
paste the 4 rubber feet at the bottom of the hulled to avoid scratches of metal housing.
Take out the “2pin / 6pin terminal block” from inside the accessory kit, and install to the modem properly.
(Figure 2.4.1)
Please refer to install the DIN-RAIL as following step:
1. Install the DIN-Rail mounting plate to the NV-700I.
(Figure 2.4.2)
2. Please use the suitable DIN-Rail to install, please refer to the dimensions of the DIN-Rail.(
Figure 2.4.3
)
3. Insert the top of the DIN-Rail into the top slots on the DIN-Rail mounting plate and the DIN-Rail mounting plate will snap into
place.
(Figure 2.4.4)