NetPing server room environmental monitoring solutions and IP power distribution units.
Copyright © NetPing east Co., Ltd / E-mail:
/ Phone: +886-2-23121582
[email protected] www.netpingdevice.com
[ENG] 8.4. [DKSF 48.5 IU] What is a "Schedule" and How to Configure It?
A «
» module allows configuring a schedule according to which a relay is going to switch on and off.
Schedule
To use the “
” module, relay control must be switched to “Schedule” or “Sc Watchdog” mode on the “AC OUTLETS” page of the
Schedule
device’s web interface. To configure the “
” module, you have to press the “
” button located on any of the eight control channels
Schedule
Schedule
of the built-in relays:
All module settings are carried out in a pop up dialogue:
Enable Control of Relay — activation of relay control. If the checkbox is not installed, the relay will not be controlled from the "
" module.
Schedule
I
: the checkbox is not installed.
n default
WEEKLY SCHEDULE
A schedule for the relay control is set in the settings dialogue . For each day of the week, six intervals can be configured in which the relay will be
activated.
The interval starts from the time the relay was switched on (the "
" column) and ends with the time off (the "
f" column). The time is indicated in
On
Of
the format "
" in the range of
. The time should increase from left to right: in the interval, the switch-on time should come earlier
hh:mm
00:00 - 23:59
