NetPing 8/PWR-220 v4/SMS, User Manual

Page: 17 / 160

NetPing server room environmental monitoring solutions and IP power distribution units.
Copyright © NetPing east Co., Ltd / E-mail: / / Phone: +886-2-23121582 support@netpingdevice.com www.netpingdevice.com
A sensor is packaged with an inseparable cable, with connectors on the ends. A cable length can be increased with the help of flat cable
sensor, which are sequentially plugged one into another. Or it can be done independently with the help of any wire with a extenders of RC-4
minimum cross section of 0,4 mm . Maximum allowable length of a flat cable is 100 m.
2
IR Transceiver IRC-TR v2
IR transceiver is plugged by a four-wire line according to the table:
Sensor Flex NetPing 8/PWR-220 v4/SMS Terminal
Labeled wire (red) C
Second wire after a labeled one D
Third wire after a labeled one +
Fourth wire after a labeled one G
A sensor is packaged with an inseparable cable, with connectors on the ends. A cable length can be increased with the help of flat cable
sensor, which are sequentially plugged one into another. Or it can be done independently with the help of any wire with a extenders of RC-4
minimum cross section of 0,4 mm . Maximum allowable length of a flat cable is 100 m.
2
Plugging NetPing AC/DIN Sockets
When plugging a socket to a device, all wires are used except for a brown one. There is a need to switch an IO line, to which a NetPing AC/DIN
socket is connected, to the status "output". When a status of an IO line is logic 0, the socket will have 220V, and a load will be turned on. When a
status of an IO line is logic 1, a socket will be cut off power, and a load will be turned off.
Sensor Flex NetPing 8/PWR-220 v4/SMS Terminal
Red +
Black G
Blue (Green) Одна из IO линий – 1/2/3/4
A relay with normally closed contacts is used to switch load in NetPing AC/DIN. This means if a control wire is not plugged anywhere, 220V will be
in the socket and a load will be switched on.
A sensor is packaged with an inseparable cable, with connectors on the ends. A cable length can be increased with the help of flat cable
sensor, which are sequentially plugged one into another. Or it can be done independently with the help of any wire with a extenders of RC-4
minimum cross section of 0,4 mm . Maximum allowable length of a flat cable is 100 m.
2
Important! Sensors of a dry contact type, a , a leakage sensor, and others are plugged to IO lines of a device. You supply voltage sensor
can plug any four sensors out of this set.
Important! A corresponding IO line should be set to an input mode in settings of a device.
Important! A brown wire is not used and must stay unplugged!