Copyright © NetPing east Co., Ltd E-mail:
Phone:+886-2-23121582
[ENG] 8.3. [DKSF 48.4 IU] What Is «Watchdog», and How to Configure It?
«
» is a specific operation mode of a power supply channel, within which specific addresses are constantly requested using ping (ICMP Echo)
Watchdog –
in a specified period of time. If there is no response, a device, which is connected to a power supply socket, is reloaded.
To use the module «
», there is a need to switch a relay management to the module «
» or «
at the page «
Watchdog
Watchdog
SWatchdog»
AC
» of a device web interface. To configure the module «
», there is a need to click the button «Watchdog», located on any of eight
OUTLETS
Watchdog
rel
ay management channels:
All parameters of the module are configured in the next pop-up dialog:
where:
Polling of Address A, B, C – is a set of checkboxes, which allow to specify addresses for polling individually.
: checkboxes are not checked
On default
If specified IP addresses are out of the IP subnetwork of the device, there is a need to indicate a gateway address to the external network at
the page «
» of a device web interface.
SETUP
If none checkbox is checked, or IP addresses for checked checkboxes are not specified, polling will not be executed and in fact, the mode «Wa
» will be disabled.
tchdog
