22
Load in watts [W] corresponds to the immediate current and voltage (P = U * I * TPF).
Current in amps [A] shows the immediate current flowing through the output.
Voltage in volts [V].
TPF (True Power Factor) shows the ratio of active and apparent power, or the ratio of resistance
and impedance. A value less than 1 means that there is a phase difference between the current and
the voltage, i.e. higher energy losses compared to a purely resistive load.
Phase in degrees (°) is the value of a phase shift between current and voltage. Depends on a load
type connected to output.
Energy in watt-hours (Wh / kWh) is the cumulative energy consumed over a time interval. The
value is the total consumption at the output since the last reset of the counter.
By default, the cumulative energy consumption is counted from the time the NETIO device was first
powered on. To reset the counter, go to the Settings > System tab and click the Reset Power
Consumption Counters button (see Figure 18). This restarts the measurements as of the current
moment.
Frequency in hertz [Hz].
Figure 18 – Resetting the consumption counter