English
2
Attach the Antennas and Connect the Access Point to
Your Computer
1.
Attach the antennas to the SMA antenna connectors on the back panel.
2.
Prepare a computer
with an Ethernet
adapter:
a.
If this computer is
already part of your
network, record its
TCP/IP
configuration
settings.
b.
Configure the
computer with a
static IP address of
192.168.0.210 and
a subnet mask of
255.255.255.0.
3.
Insert an Ethernet
cable in the Ethernet
port of the computer
(point
A
in the
illustration).
4.
Securely insert the other end of the cable into the Ethernet LAN port on the
back panel of the access point (point
B
in the illustration).
5.
Connect the power adapter to the access point and plug the power adapter
into a power outlet.
6.
Verify the following:
Power LED
. The Power LED is green. If the Power LED is off, check
the connections, and check if the power outlet is controlled by a wall
switch that is turned off.
Test LED
. The Test LED blinks amber at startup and turns off after
about one minute.
LAN LED
. The LAN LED indicates LAN speeds: green for 1000 Mbps,
amber for 100 Mbps or 10 Mbps. If no link is detected, the LAN LED is off.
WLAN LED
. The WLAN LED is blue, indicating that the wireless LAN
(WLAN) is ready.
A
B
LAN port
Console port
Power
connector
Antenna connector
Antenna connector
