Reference Manual for the 54 Mbps Wireless Travel Router WGR101
Wireless Configuration
4-7
February 2005 (202-10034-03)
Default Factory Settings
The WGR101 default factory settings are shown below. You can restore these defaults by pressing
and holding the Factory Default Restore button on the rear panel for 10 seconds. After you install
the WGR101 wireless travel router, use the procedures below to customize any of the settings to
better meet your networking needs.
How to Set Up and Test Basic Wireless Connectivity
Follow the instructions below to set up and test basic wireless connectivity. Once you have
established basic wireless connectivity, you can enable security settings appropriate to your needs.
1.
Log in to the WGR101 at its default LAN address of
http://192.168.0.1
with its default user
name of
admin
and default password of
password
, or using whatever LAN address and
password you have set up.
2.
Click
Wireless Settings
in the main menu of the WGR101.
3.
Choose a suitable descriptive name for the wireless network name (SSID). In the SSID box,
enter a value of up to 32 alphanumeric characters. The default SSID is NETGEAR-TRAVEL.
FEATURE
DEFAULT FACTORY SETTINGS
Wireless Access Point
Enabled
Wireless Access List (MAC Filtering)
All wireless stations allowed
SSID broadcast
Enabled
SSID
NETGEAR-TRAVEL
11b/g RF Channel
11
Mode
g and b
Authentication Type
Automatic
WEP
Disabled
Note:
If you use a wireless computer to configure wireless settings, you will be
disconnected when you click Apply. Reconfigure your wireless adapter to match the
new settings or access the wireless travel router from a wired computer to make any
further changes.
