Manually set up the AP Internet connection
[router mode]
If the AP is in router mode, you can view or change the AP’s Internet connection settings.
Note: The information in the following sections is not required if the AP is operating
in AP mode. In AP mode, the Internet settings can be provided by the routing device
to which the AP connects. Therefore, in AP mode, these Internet settings are masked
out in the local browser UI.
Specify a dynamic or fixed WAN IP address Internet
connection without a login [router mode]
Usually, the quickest way to set up a dynamic or fixed Internet connection is to allow
the Setup Wizard to detect the Internet connection when you go through the initial
log-in process as described in Connect the AP to a modem and log in for the first time
on page 30 or,
after
initial setup, in Use the Setup Wizard [router mode] on page 42.
After you install the AP and it is in router mode, you can manually specify the dynamic
or fixed Internet connection or change it. (These dynamic and fixed IP settings are not
required if the AP is operating in AP mode.)
For this procedure, use the settings that your Internet service provider (ISP) gave you.
If you are not sure, contact your ISP.
To specify or view the settings for a WAN Internet connection that uses a dynamic
or fixed IP address and that does not require a login:
1. Launch a web browser from a computer or mobile device that is connected to a WiFi
network or LAN port on the AP.
2. Enter http://www.routerlogin.net in the address field.
A login window displays.
If your browser displays a security warning, dismiss the warning. For more information,
see Dismiss a browser security warning on page 39.
3. Enter the AP local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select BASIC > Internet.
User Manual
43
Manually Set Up Internet
Settings [Router Mode]
WiFi 6 AX1800/AX3200 Dual Band Wireless Access Points, WAX202 and WAX206
