Overview
8
Orbi High-Performance
AC3000
Tri-band
WiFi
System
LED Behavior
The following table describes the Orbi LED behavior.
Table 1. LED descriptions
LED
LED behavior
Power
The Power LED is located above the
Power On/Off
button on the rear panel.
•
Solid green
.Power is on.
•
Solid amber
. The router or satellite is rebooting.
•
Blinking amber
. Resetting to factory default settings.
•
Blinking red
. The firmware is corrupted.
•
Off
. Power is not supplied.
Router ring
The ring LED is located on the top.
•
Solid white
. The router is booting.
•
Off
. The router finished booting and is working normally.
•
Blinking white
. The router is resetting to factory settings.
•
Blinking amber
. The router cannot connect to the Internet. See
•
Blinking blue and magenta
. The Internet connection is blocked because
you set up Internet traffic metering and reached the maximum allowed
amount of Internet traffic.
Satellite ring
The ring LED is located on the top.
•
Solid white
. The satellite is booting.
•
Off
. The satellite finished booting and is working normally.
•
Blue for 10 seconds
. The connection between the router and the satellite
is good.
•
Amber for 10 seconds
. The connection between the router and the
satellite is fair.
•
Blinking magenta
. The satellite is not connected to the router.
•
Magenta for 10 seconds
. The satellite cannot get an IP address from the
router.
Router ring and satellite
ring during sync
The ring LEDs are located on the top.
•
Blinking white
. The
Sync
button was pressed.
•
Blue for 3 seconds
.The sync between the router and satellite succeeded.
•
Magenta for 3 seconds
. The router and satellite failed to sync. See
Router and Satellite Do Not Sync
99.
