-
IEEE 802.3x Full-duplex flow control
-
IEEE 802.1Q VLAN tagging
-
IEEE 802.3ad Link aggregation (LAG with LACP)
-
IEEE 802.1p Class of Service (QoS)
-
IEEE 802.3az Energy Efficient Ethernet (EEE)
-
IEEE 802.1af (PoE)
-
IEEE 802.1at (PoE+)
-
IEEE 802.1bt (PoE++)
•
AutoSensing and autonegotiating capabilities for all ports.
•
Auto Uplink™ technology is supported on all ports.
•
Automatic address learning function to build the packet-forwarding information
table. The table contains up to 16K Media Access Control (MAC) addresses.
•
Store-and-forward transmission to remove bad packets from the network.
•
Active flow control to minimize packet loss and frame drops.
•
Per-port status LEDs and system status LEDs.
•
NETGEAR green power-saving features:
-
Energy efficiency mode that fully conforms to the IEEE802.3az standard
-
Per-port automatic change to a lower power mode when the port link is down
Safety instructions and warnings
Use the following safety guidelines to ensure your own personal safety and to help
protect your system from potential damage.
To reduce the risk of bodily injury, electrical shock, fire, and damage to the equipment,
observe the following precautions:
•
This product is designed for indoor use only in a temperature-controlled and
humidity-controlled environment.
Note the following:
-
For more information about the environment in which this product must operate,
see the environmental specifications in the appendix or the data sheet.
-
If you want to connect the product to a device located outdoors, the outdoor
device must be properly grounded and surge protected, and you must install an
Hardware Installation Guide
7
Introduction
8-port Ultra60 PoE++ Multi-Gigabit (2.5G) Ethernet Plus Switch MS108EUP