NETGEAR ANT2405 - 5 dBi Omni-directional Antenna, Installation Manual

Page: 6 / 24

Installation Guide for the 9 dBi Omni-directional Antenna ANT2409
1-2
v1.0, April 2008
• Lightning Arrestor
• Reverse N/SMA Adapter
• Antenna mounting assembly (tube, grommet, 2 brackets, screws, washers)
• L shape bracket for top & ceiling mounting
• Screws, bolts, washers, U-bolts and plastic anchors
• This Installation Guide, and a Warranty and Support Information card
If any of the parts are incorrect, missing, or damaged, contact your NETGEAR
dealer. Keep the carton, including the original packing materials, in case you need
to return the product for repair.
To obtain optimal results in extending wireless range with antenna installations,
consult a qualified professional installer for site survey and installation assistance.
Antenna cable for connecting the wireless device is sold separately. Please use a
NETGEAR model ACC-10314-01, 02, 03, 04, or 05 cable.
In the U.S., the ANT2409 antenna should only be used with devices that have
been FCC approved for use with it. Please check the NETGEAR website at
http://www.NETGEAR.com/go/antennas_fcc for an updated list of FCC approved
devices.
For Europe, use of any antenna requires careful planning and extra consideration
to comply with EU emissions and health standards and regulations. Antenna
installation must comply with the maximum level authorized by each country.
Please check the NETGEAR website at
http://www.NETGEAR.com/go/antennas_eu for a list of restrictions and approved
devices.
Note: A ground cable is not included but required for outdoor
installation. The grounding cable must be equivalent or better
than: AWG 10, UL 1015, Stranded, 600 V, 105
o C, green or
green/yellow insulation, 2 clip of 5.5 mm inner diameter
cramped at both ends, cable no longer than 5 meters