MAN-0148, Rev 1
13
March 2016
Figure 5: Cable preparation
Note: If required, use cable glands which have been approved for hazardous locations.
Warning
Before wiring, ensure that power to transmitter is switched off.
When connecting cable wires, use a small screwdriver to gently press down and hold the spring connector open. Insert the
appropriate wire into the open connector hole, releasing the screwdriver to secure the wire. See Figure 6.
Figure 6: Connecting wires
Warning
Avoid touching electronic components, as they are susceptible to electrostatic discharge (ESD). Refer to
Appendix A, “Electrostatic Sensitive Device (ESD)”.
4 Inches
Hazloc cable gland
A: Drawing showing of cable without
l d
B. Picture of cable showing gland and insulation
C. Picture of cable wired to junction box and
sensor
Millennium II
Sensor
Cable gland &
Armored cable
Shield wires from each twisted pair
connected to “GND” (Earth Ground) on
terminal block.
Shield wire from flexible Armored
cable and sensor ground wire
(Green wire) connected to Earth
grounding screw in junction box
¾-in. NPT
stopping plug.
Net Safety
Junction Box
