
Page 7
4.2
Set up the Receiver and Connect to TV
Screw the Antenna onto one end of the Re-
ceiver. Adjust the angle of the Antenna so that
it is approximately vertical.
The receiver can be mounted vertically using
the screw holes provided, or rested in a hori-
zontal position.
Fit the 9V Mains Power Supply (it has a
cylindrical plug) to the Receiver (DC 9-
12V) and plug it into the Mains.
Switch the power on. The red indicator
light will light to show it is on.
Fit one end of the Receiver Video/Audio Lead to the Receiver, con-
necting one colour to “VIDEO OUT” and the other colour to “AUDIO
OUT”.
Fit the other end of the Receiver Video/Audio Lead to the direct input
video and audio connectors of your TV. Connect the colour you con-
nected to “VIDEO OUT” on the Receiver to Video In on the TV, and
the colour you connected to “AUDIO OUT” on the Receiver to the
Audio In socket on the TV.
As an alternative, you may prefer to plug this in to the Video/Audio
connectors on a video recorder or VCR.
If you only have a SCART input socket for your TV, you can fit the
cable through an appropriate adaptor (not supplied, but available as an
accessory).
The cable (and the signal it carries) is not suitable for direct connection
to your TV aerial or antenna socket.
Turn the TV on, and switch it to the direct video/audio input.
Page 5
SCREW ANTENNA
ONTO RECEIVER
FIT
POWER
SUPPLY
HERE
FIT ONE
COLOUR
CONNECTOR
HERE
FIT OTHER
COLOUR
CONNECTOR
HERE