
Page 6
If you are running the nest box on batteries, open the Battery Box, re-
move the battery holder and fit 4 size D batteries
(observing the polarity shown on the battery holder).
Replace the battery holder, ensuring that it is securely
connected to the PP3 snap fitting inside the Battery
Box.
Ensuring that the connectors are in-
side the Battery Box, run the power cable out of the
Battery Box through one of the slots in the base, and
fit the lid onto the Battery Box, using the 4 screws
provided.
If you decide to use the mains power supply, disconnect the battery
holder from the PP3 snap fitting in-
side the Battery Box. Remove the
battery holder. Connect the PP3 snap
fixing on the end of the Mains Power
Supply Unit to the PP3 snap fixing
inside the Battery Box, run the 2 ca-
bles out of the battery box and fit the
lid, using the 4 screws provided.
Connect the other end of the power cable to
the mating connector on the camera inside
the Nest Box. Position the joined connectors
inside the Nest Box and pass the cable out
through the small hole in the side formed
when the side panel is put back in place.
Fit the side panel back onto the Nest Box and
replace the securing peg.
Page 4