23
SMS CoMMaNDS
coMMand oPeration
a
arM
h
hoME
X
EXCLUDE
p
proGraM
1
E
ENTEr
f
fIrE
D
MEDICaL
S
paNIC
11E ~ 88E
opEraTE aUX
oUTpUTS
T
TEXT
2
1
See page 33
2
See page 34 and the Installer Manual for detail
D8XCEL and D16XCEL control panels can be operated and
programmed by SMS (TXT) messaging from any mobile phone.
This section covers programming by direct SMS messaging from a
mobile phone.
operation by SMS
SMS commands are extremely flexible in their
format.
Use oF sPaces
The panel automatically ignores spaces in
SMS programming commands. however,
spaces are important in Text output
commands, see page 34.
UPPer or loWer case is ok
you can use either UppEr CaSE or lower
case characters in your messages, or even
mixed case without a problem.
coMMas
Commas are used to separate words when
reprogramming text output, so use commas
only when the command allows it.
MUltiPle coMMands
you can send multiple programming
commands in one text message. See the
Installer Manual for detailed instructions.
acK
(acknowledged)
aCK is the panel saying ‘I have received the
command and applied it’.
naK
(Not acknowledged)
The ‘NaK’ response indicates that the
command was not accepted by the panel.
Check the format of your SMS or perhaps
the command should have been sent in
Installer program mode.
sMs resPonses
sMs is received FroM a KnoWn Phone
nUMber
(one of the phone numbers programmed
at P180e~P189e)
a) The panel will respond to any SMS command
from a known phone number.
b) a correctly formatted command will be actioned
and replied with aCK (acknowledged).
c) If you send an incorrectly formatted SMS or the
wrong user code the panel responds with NaK (Not
aCK).
sMs is received FroM an UnKnoWn
Phone nUMber
a) If the user code is valid the panel will action the
command and reply.
b) If the user code is not valid the panel will ignore
the command and reply with the message “The
SMS just received is wrong. No further responses
until correct SMS received”
c) The panel ignores further attempts to operate it
with an invalid user code.
d) once a correct command with a valid user code
is received the panel will action and reply.
e) If the valid user code is not the master user
code, but the command requires the master code
then the reply is “wrong message”
