29
programming User Codes
In User program Mode.
refer to the User Code options table on page
25 then enter the option number of the user
code you want to program.
Touch
+
+
3 digit option
number
The current user code is displayed.
Now enter your new user code (pIN). The
code can be 3 to 6 digits in length.
Touch
+
Then enter the pIN again to confirm.
Touch
+
Your new PIN
Your new PIN
Note 1. User codes must not
start with zero. (The panel will
allow codes beginning with zero
to be programmed but they will
not operate the panel. This is an
alternative method for disabling
user codes.)
Note 2. all codes must be unique
to each other. Codes are rejected
if already used. Some codes that
are similar to existing codes may
also be rejected.
Touch to delete a user code
The new user code will be displayed.
• Up to 56 Keypad Codes can
be programmed to control your
XCEL panel.
• Keypad Codes can be 3 to 6
digits in length.
• User Code 1 is also the Master
Code which is used to enter
User program mode.
• User Codes 2 to 56 can be
programmed to be radio Codes
or access Cards as required.
ask your installer.
• If a code has been pro
-
grammed by your installer to be
an arm only code, then that user
code can arm but not disarm the
panel. This is handy for cleaners,
temporary staff etc.
