If maintenance light continues to blink after rinsing it means less than
1.2 L / 41 oz water was added. Repeat step 7.
❽
Press brewing button
to start rinsing the machine, pump will run. Machine will stop
automatically when the water tank is empty. Remove and empty the drip tray and place
back. The machine will automatically switch OFF when the descaling process is done.
The machine is now ready for use.
❻
Rinse
the water tank, drip tray
and cup support thoroughly to
avoid any residue.
❼
Refill the water tank
with
1.2 L / 41 oz fresh potable water.
❹
To enter the descaling mode:
Ensure machine is OFF and slider is closed. Press brewing button for 6
seconds - both dials will flash for confirmation. On the recipe dial, select Ristretto icon, press brewing
button to validate selection. Then, on the temperature dial, select high level “I” to confirm or lower
level “O” to cancel, press brewing button to validate choice. Ristretto icon blinks to confirm you are in
descaling mode.
❺
Press brewing button to start the descaling cycle; descaling
agent will flow through the coffee and hot water outlets.
When machine stops and maintenance light blinks, remove
and empty the drip tray and place back. Push brewing
button again. Machine will stop when water tank is empty.
Ristretto icon will blink during the entire descaling process. Maintenance light will be steady ON
while machine is automatically proceeding. Maintenance light will blink when a manual user
action is required.
Throughout the descaling process you can pause
at any time by pressing the brewing button (e.g. to
empty and place back your container). Continue by
pressing the brew button again.
Descaling
EN
22
10119_UM_EXPERT&MILK_BREVILLE.indb 22
19.08.16 12:38
