Nesco NC-58100 STEAM KLEAN, Instruction Manual

Page: 16 / 20

Round or bend sprayer installation
Insert round or bend sprayer to the short sprayer directly; follow the instruction
shows on figure ; adjust the direction of the sprayer.
Glass brush installation
Insert glass brush to the General spray nozzle and then trigger the big hook of
glass brush , and push glass brush up and clutch it onto the body of the
general spray nozzle.
Adding water
1. Remove the plug; cut off the electricity.
2. Press the steam to release the pressure until no steam is coming out.
3. Slightly open the safety cover; release the remaining steam; place the steam
cleaner in a cool place for 5 minutes; open the safety cover completely.
4. Use funnel and measuring cup to add some cool or warm water.
5. Put back the safety cover and secure it firmly.
- Caution: Do not overfill, or it will cause unnecessary steam pressure and
influence the creation of steam.
After use
1. Remove the plug after using; cut off the electricity.
2. Press the steam button to release the remaining steam.
3. Slightly open the safety cover; release the remaining steam ; place the steam
cleaner in a cool place for 5 minutes; open the safety cover completely.
4. Dry the remaining water in the tank; clean the surface of the steam cleaner.
5. Put back the safety cover and secure it firmly.
Note
Re-install the safety cap onto the machine body and tighten it in position.
15