OOO Neomatica. Terminal ADM007 GLONASS / GPS. Rev.1.3 dated 13.09.2019
8
Insert the SIM card into the holder with a deactivated PIN code request, activated data
transmission service via GPRS, SMS and sufficient balance for these services
Supply the power to the wires according to the layout in Figure 3: for the red wire - plus of the
vehicle network, for the black - minus of the vehicle network (housing, GND). When connecting the
plus of the vehicle network to the tracker, install a 2A fusible as close as possible to the point of
connection to the vehicle network, which is especially important when connecting directly to the
battery clamp.
Figure 3
– Standard connection layout of the tracker
If there is valid satellite data and an established connection to the server, the tracker will
determine the time, coordinates and transmit information packets to the server, which will be marked
by a single flashing of the green and blue LEDs.
It is highly recommended to conduct a preliminary test of the tracker's performance in the
laboratory, using a power supply instead of the vehicle network, providing an output voltage of 8 to
45 VDC and a current of at least 1A.
5 Setting the tracker
5.1 Connecting to the Configurator
To connect the ADM007 tracker to a personal computer using Bluetooth wireless technology, you
should do the following:
1) Bring the Bluetooth adapter of the PC to the working state;
2) Start the ADM Configurator program version not older than 2.2 (available for download at
http://neomatica.com);
3) Turn the Configurator to the Bluetooth radio connection mode. To do this, you need to select
