SECTION IV. INSTALLATION STEPS
3/8" DRAIN CLAMP ASSEMBLY (FIGURE 5)
D. Drain Clamp Installation:
Choose the drain outlet
location per Sec. III. The following are instructions
for discharging into the sink drain pipe. (Refer to Fig. 5.)
13.
Position the Drain Clamp on the sink drain pipe above
the drain trap. Allow room for drilling. Tighten securely.
14.
Use a battery powered or properly grounded drill.
Using the Clamp port as a drill guide, drill a 7/32" hole
through the wall of the drain pipe. Do NOT penetrate the
opposite side of the pipe.
15.
Locate the 3/8" Black Drain Tubing connected to the
Dispensing Faucet. Route the tubing to the Drain Clamp
and trim to length.
NOTE:
When cutting the polytubing make clean, square
cuts, failing to do so could result in poor connections and
possible leaks.
CAUTION:
The lowest point of the line should be the point
of connection to the Drain Clamp. There should be no sag
in the line as this may cause excessive noise as the reject
water is flowing to drain
• Insert the tubing into the Drain Clamp. Make sure
the tubing is pressed all the way in to create a
pressure-tight connection. (Refer to Fig. 5.)
• If you want to pull the tubing out for some reason,
push the ring around the tubing in and pull the
tubing out.
11
Sink
Do Not
Install Here
Install
Here
Maximum
Displacement
From Top
Center - 45°
Drain Line
From Air Gap
(Air Gap Only)
Vertical
Mount
Horizontal
Mount
Sink
