Nemco CanPRO 56050-(), Operating Instructions

Page: 2 / 5

Replacing Cutter from Cutter Housing Assembly
1. Hold Cutter Shaft #26 with wrench and loosen Cutter Locking Bolt #31 (left hand thread) with another wrench by turning clockwise.
2. Remove Cutter Washer #30 and Cutter Spacer #29 and Cutter #28.
3. Replace with new Cutter.
4. Reverse steps 2 and 1 to re-assemble.
No. Part # Description
24 56052 Rubber Depth Control
25 56053 Adjusting Screw
26 56054 Cutter Shaft
27 56055 Cutter Housing
28 56029 Cutter
29 56024 Cutter Spacer
30 56056 Cutter Washer
31 56057 Cutter Locking Bolt
32 56058 Rubber Pipe Bumper
33 56059 Square Pipe
34 56060 Plastic Pipe End
35 56043 Pin & Chain Assembly
36 56070 Table Base Assembly
38 56063 Under Clamp
39 56064 Table Base Screw
40 56065 Anti-Slip Rubber Pad
41 56022 Cutter Housing Assembly
42 56023 Under Clamp Assembly
43 56068 Side Pin Assembly
44 56027A-B Bottom Cutter Bearing
45 56027A-T Top Cutter Bearing
46 56215 Gripper Bearing
No. Part # Description
1 56030 Top Handle Knob Cover
2 56031 Top Handle Knob
3 56032 Top Handle Knob Screw
4 56033 Top Handle
5 56034 Handle Screw
6 56027 Top Handle Bearing
7 56035 Gripper Housing
8 56036 Gripper Shaft
9 56028 Gripper
10 56037 Bushing
11 56038 Bushing
12 56039 Locking Mechanism
13 56040 Locking Pin
14 56041 Allen Set Screw
15 56334 Gripper Housing Spring
16 56026 Side Locking Pin
17 56044 Bushing
18 56045 Bushing
19 56046 Side Handle Shaft
20 56216 RH Side Handle
21 56048 Mechanism Housing
22 56049 Ball End Set Screw
23 56051 Adjusting Nut
CanPro Replacement Parts
Model Numbers : 56050- ( )