![background image](http://html2.mh-extra.com/html/nelson/n1500i/n1500i_fast-start-manual_3930957020.webp)
Stud welding unit N1500i
Version 1.31 7.June.2013
Manual part number: 729-110-027
15
Nelson Stud Welding, Inc. • 7900 West Ridge Road • Elyria, Ohio 44035 • USA
will be replaced by the desired custom values. When the orange LED
of the preset button being pressed turns ON, the selected preset has
been successfully programmed.
The weld parameter presets depends on to chosen weld method (short cycle,
drawn arc).
2.2.6
Recommended Weld Parameters
The values specified in the tables and diagrams respectively must be
seen merely as guide values, which were achieved under optimized
welding conditions.
The best possible weld parameters must always be determined with
proper attention to factors such as the material and surface quality of
the workpiece, plate thickness, welding position, stud type, stud
dimensions, etc. in trial welds.
Attention must be paid to the fact that the trial welds are for the most
part equivalent to the real conditions in the current production pro-
cess.
In obtaining the best welding result, the electrical and mechanical
weld parameters must be preceisely adjusted to the respective wel-
ding task.
Upon suspicion of faulty welds the settings on the welding unit and
the weld gun must be optimized.
The weld parameters in the tables and in Stud Expert are provided as is,
without warranty of any kind, either expressed or implied, including, but not
limited to, the implied warranties of merchantability and fitness for a
particular application. Performance suitability for any specific application
should be determined by the user. The user assumes all liability of the use or
the results of the use of the recommended weld parameters.
Nelson cannot assume any responsibility for updating or correcting the
welding advice or guide values once they have been given, nor does the
provision of information create, expand or alter any warranty with respect to
the sale of our products.
Note!
Note!