11
PREPARATION
DANGER!
Danger of injury!
Before all adjustments and
settings:
• Turn the machine off.
• Pull out the power plug.
• Wait until the machine is still.
Danger of burning!
Drills and chisels become very hot
during operation. You can be
burned by this.
• Change the drills or chisels
after they have cooled down.
Attachable handle
Never use the impact drill without the attachable handle (7). The attachable handle
provides additional support and allows you to work exhaustion-free. The attachable
handle is intended for both right-and left-handed persons.
•
Loosen the wing screw (c2) of the attachable handle
(7) by turning it counter-
clockwise.
•
Guide the drill chuck (1) of the impact drill through the attachable handle.
•
Then turn the attachable handle to the position which is best for you.
•
Turn the wing screw (c2) clockwise until the attachable handle sits tightly and
can no longer be moved.
Depth gauge
With the depth gauge
(c1), you can drill several holes with the same drilling depth.
•
Loosen the wing screw (c2) of the attachable handle (7).
•
Guide the depth gauge (c1) through the opening on the attachable handle.
•
To set the desired drilling depth.
•
Pull the depth gauge out far enough so that the distance between the point of
the drill and the point of the depth stopper is the desired drilling depth.
•
Turn the wing screw (c2) clockwise until the attachable handle sits tightly and
can no longer be moved.
Using screw tools
When using screw bits, you should always use a universal bit-holder.
Only use screw bits which fit the screw head. For screws, always set the changeover
switch (x) "(Drill/ impact drill)" to the symbol. Make sure that the screw tools are used
only with reduced rotation speed (see Operation).
